![]() For example, if you add a camera with channel 2, then the channel number should be changed to 1 in the URL. The channel starting from 0 in the URL is counted as the first channel on the NVR. When adding cameras on different channels from the NVR, the steps are the same as adding a single camera, just repeat the same steps to add with the same IP (the IP address of the NVR) address, and only need to pay attention to modifying the channel field of the URL. ![]() If you can’t find the corresponding model for Model settings, just use the first default *model, no modification is required, and the model is not required to be correct.Ĭ. Cameras with a resolution of 8MP and above can only use the sub-stream to live view, because when you use the Reolink protocol to add a camera, you actually use the RTMP protocol, while RTMP does not support the h.265.ī. Note: when you use Reolink protocol to add a camera, please pay attention to the following points.Ī. You can live view the camera on Blue Iris now. Type your camera’s username ( admin by default) and password in the URL, click OK. Make sure the RTSP and ONVIF port numbers are the same as your camera’s. Enter the camera IP address and password. Step 2: Choose Reolink as a protocol for the Make setting. Step 1: Launch Blue Iris, right-click to choose Add New Camera, and click OK to add a camera in LAN Method 2: Add the camera via Reolink protocol Enter the camera IP address and password, and make sure the RTSP and ONVIF port numbers are the same as your camera’s, click OK. Confirm Onvif protocol is selected by default for Make Setting. Launch Blue Iris, right-click to choose Add New Camera, and click OK to add a camera in LAN Method 1: Add the camera via ONVIF Protocol Manually Note: You can also open the ports via Reolink NVRs or via the web browser, see: How to Configure Reolink Ports Settings. After opening the ports, do not forget to Save your configurations. Note: TrackMix Wired LTE can only support this feature when using wired connection.īefore getting started, login to your device on the Reolink Client, go to Device Settings > Network > Advanced > Server settings to open relevant ports for the device. Applies to: All Reolink NVRs and cameras except all battery-powered cameras, E1 and Lumus. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |